These gages directly measure the diameter of chamfered holes. No setting master is necessary. When the three blade plunger is pressed against a fl at surface, the gage should read the set number stamped on the back of the indicator. In case of wear, the gage may be adjusted to read the proper number. 0 - 25 mm range in case of wear, the gage may be adjusted to read the proper number.

Starrett® Chamfer Gage, Internal, Series: 683, 0 to 25 mm Measuring, Graduations: 0.02 mm, 3-Blade Plunger, 7/8 in Dia Dial, Yellow Dial, Hardened Tool Steel

• When the three blade plunger is pressed against a flat surface, the gage should read the set number stamped on the back of the indicator
• No setting master is necessary
• Gages will measure the smallest diameter of any chamfer within the range of angles printed on the dial face of the gage
• Gages are also available with electronic indicators on request
• Deluxe padded case
• All ground surfaces are of hardened tool steel
• Indicators are AGD design
• Gages directly measure the diameter of chamfered holes
• For 0 - 90 deg Dial reading