Michigan Drill® 300HR 37
send Send print Print

Michigan Drill® 300HR 37

Michigan Drill® 300HR 37 Half Round Jobber Length Drill Bit, #37 Drill - Wire, 0.104 in Drill - Decimal Inch, 118 deg Point, HSS, Bright

  • TIEPN: MIC 300HR-37
  • MPN: 300HR 37
  • Min. Order Qty: 1
  • Quantity Interval: 1
  • loading

Michigan Drill® Jobber Length Drill Bit, Half Round, Series: 300HR, Imperial, #37 Drill - Wire, 0.104 in Drill - Decimal Inch, 2-1/2 in Overall Length, 1-7/16 in Cutting Depth, 1-7/16 in Flute Length, Straight Shank, 118 deg Point, HSS Cutting Edge, HSS, Bright, Applicable Materials: Aluminum, Brass, Copper, Hard Rubber, Fiberglass, Magnesium Alloys and Die Cast Parts and Other Materials

Applicable Materials      :      Aluminum, Brass, Copper, Hard Rubber, Fiberglass, Magnesium Alloys and Die Cast Parts and Other Materials
Cutting Depth      :      1-7/16 in
Cutting Edge Material      :      HSS
Drill Diameter Measurement System      :      Imperial
Flute Length      :      1-7/16 in
Overall Length      :      2-1/2 in
Series      :      300HR
Shank Type      :      Straight
Type      :      Half Round
Drill Size - Wire      :      #37
Drill Size - Decimal Inch      :      0.104 in
Point Angle      :      118 deg
Material      :      HSS
Finish      :      Bright
  • These drills allow greater chip clearance and have less tendency to run-out in deep hole drilling operations
  • Hole sizes are more accurate
  • The open flute design allows the greatest volume of chip removal with high feed rates
  • They are also successfully used in shallow hole drilling of aluminum and magnesium alloys and die cast parts